So - short story:
I liked the way Hope floating rotors look so I grabbed a set for my bike. Running them with Saint 810 on a V10.4
the rear adapter I have is ticking against it - too tight clearance -- any recommendations? Brand of adapter? Get busy with the bench grinder? I was considering adding a .5-1mm washer to the brake side axle..
What about the caliper? the mounting points are pretty close, maybe I could 'soften' the edges or try to off-center the pads a .25mm+
I liked the way Hope floating rotors look so I grabbed a set for my bike. Running them with Saint 810 on a V10.4
the rear adapter I have is ticking against it - too tight clearance -- any recommendations? Brand of adapter? Get busy with the bench grinder? I was considering adding a .5-1mm washer to the brake side axle..
What about the caliper? the mounting points are pretty close, maybe I could 'soften' the edges or try to off-center the pads a .25mm+
Last edited: