I'm asking this here, becouse..... this is the best place to get good info....
hi guys
been riding with 1\10 setup (on my AM bike)
36teeth front N\W
11-40 (oneup) cassette
I find that for using this setup, I need the chain to be long.
when its on the 40 \42 teet at the back, its OK.
but when using higher gears, like the 11teeth, that bring the chain to bee too free, with not enough tension.
the problem with this is when riding down the hill. when you use the smallest gear at the cassette.
what leads sometimes to the chain bounc out off the front chainring. (even with upper guide)
is there a solution for that?
thanks
hi guys
been riding with 1\10 setup (on my AM bike)
36teeth front N\W
11-40 (oneup) cassette
I find that for using this setup, I need the chain to be long.
when its on the 40 \42 teet at the back, its OK.
but when using higher gears, like the 11teeth, that bring the chain to bee too free, with not enough tension.
the problem with this is when riding down the hill. when you use the smallest gear at the cassette.
what leads sometimes to the chain bounc out off the front chainring. (even with upper guide)
is there a solution for that?
thanks