Rennen SS setup

[ThePriceSeliger]

Ok... I'll try my best to explain, but it might not be super.

I have the Rennen SS tensioner and the hub spacers. The actual tensioner doesn't line up well the my chainrings. It's to close to the spokes and not far enough out.

I am at school and I don't have any pictures, but I will be home for the summer on Thursday. Any one have any first hand experience with the Rennen SS stuff.

[ThePriceSeliger]

Anyone?

[w00dy]

Unless the guide is adjustable. Take the spacers from an old cassette and line the chainring up manually.

[SpaZwEll]

I've adjusted my Rennen two ways. Put it in a vise and bend it close to where you want it. And the better way was leave it on the bike. Take off the rolller and slide a crescent wrench on and bend it slightly to get the correct alignment. Just do it in small increments to be safe.

[arboc!]

dont use a tensioner, its that simple... unless the porter has vertical d/outs

[Arsbars]

I think the rennen has washers on both side of the roller. This allows you to move the roller side to side by movin the washers from one side to the other