PDA

View Full Version : Replacing 2001 Bullit Pivot Bolt?

Bullit21
11-23-2005, 01:09 PM
Guys,

I bought the new Bullit bearing kit from Santa Cruz but I am having a hard time getting the old hex nut bolt out of the pivot. The bolt is tightly recessed in the frame pivot hole so it is hard to find a wrench attachement narrow enough that can fit in there to get the bolt out. Do I have to go to a shop for this? Thanks.:help:
Salami
11-23-2005, 01:22 PM
Use a thin wall 19mm or 3/4" socket. Some of the Craftsman sockets I have are just thin enough to fit in and loosen the nut.
Bullit21
11-23-2005, 02:27 PM
Use a thin wall 19mm or 3/4" socket. Some of the Craftsman sockets I have are just thin enough to fit in and loosen the nut.

Thanks Salami. I can't wait to get it set up.:drool: